Unplug your display from the computer to prevent getting zapped.
Clear aside your work area. Put a towel or electrostat mat underneath the monitor where you'll perform the surgery.
lay monitor down flat on cloth
using 2 mm hex key unscrew the 3 hinge fastners
Using a 2.5 mm hex key, unscrew the 12 screws around the perimeter of the display
this is what I used...
you may want to place another cloth directly underneath the hinge area to avoid your hex key from accidentally scraping the plastic casing.
Remove the hinge
pull out the hinge and the display plastic. Set them aside in a safe place.
remove the outer metal shielded assembly
Use a Phillips screwdriver for this part.
Don't forget the two screws underneath the silver tape. Gently peel back from the outer edges to reveal these screws.
The belly of the beast!
The old Ambit inverter.
begin unscrewing the 4 screws holding the Ambit inverter board in place. Remove the electrical tape temporarily to the side.
gently pry out the connectors attached to the old inverter board.
Remove the old board and place it back into an anti-static bag.
Old Ambit part side by side with new Moniserv replacement. Notice the differences of the board.
Connect the MoniServe inverter board.
secure in place.
Did you forget something?
Of course! The electrical tape.
Reassemble your monitor and cross your fingers.
The old Ambit part makes a great paperweight.